Preparing the workpiece support

The free end of long workpieces must have something placed underneath it or be supported.

Adjusting the height of the workpiece support (see figure I)

  • Place your workpiece on the saw table for the power tool.
  • Loosen the locking knob (10) and adjust the height of the workpiece support (12)so that your workpiece lies flat.
  • Re-tighten this locking knob.

Extending the saw stand (see figure J)

The saw stand can be extended on both sides.

  • Place your long workpiece on the saw table for the power tool.
  • If necessary, loosen the corresponding locking knob (4) and pull the table extension (5) outwards until it reaches the required length.
  • Re-tighten this locking knob.

Sawing workpieces of the same length (see figure K)

The length stop (11) can be used for easily sawing workpieces of the same length.

  • Pull the length stop all the way upwards and position the workpiece support at the required distance from the power tool saw blade.