Starting Operation
Inserting the battery (see figure A)
Push the charged battery pack (8) into the battery holder (14) until it clicks into place.
Setting up
Place the cordless worklight on a stable, level surface. Make sure it is secure.
The safety brackets (3) protect the light (1) from damage, should the cordless worklight be accidentally knocked over.
Fastening to the Tripod
You can use the tripod mount (9) to screw the cordless worklight onto a tripod.
Attach the cordless worklight firmly to the tripod. Ensure the cordless worklight cannot come loose and/or fall over.
Ensure that the tripod has a firm footing.
Switching on/off and adjusting the brightness
On/off switch | Function |
|---|---|
Press once | Switches on the cordless worklight, dimmed (level 1) |
Press twice | Switches on the cordless worklight, dimmed (level 2) |
Press three times | Switches on the cordless worklight, full brightness (level 3) |
Press four times | Switches off the cordless worklight |
If the cordless worklight has been switched on for approx. five minutes, it will be switched off immediately the next time the button is pressed.
Temperature Dependent Overload Protection
If the permissible operating temperature is exceeded, the cordless worklight switches off. Let the cordless worklight cool down and then switch the cordless worklight back on.
Battery Charge Indicator (Cordless Worklight)
When the cordless worklight is switched on, the five LEDs of the battery charge indicator (6) display the state of charge of the battery (8).
Battery charge indicator
The green LEDs on the battery charge indicator indicate the state of charge of the battery. For reasons of safety, it is only possible to query the state of charge when the cordless worklight is switched off.
Press the button for the battery charge indicator 
or 
to show the state of charge. This is also possible when the battery is removed.
If no LED lights up after pressing the button for the battery charge indicator, then the battery is defective and must be replaced.
Battery model GBA 18V...
LEDs | Capacity |
|---|---|
3× continuous green light | 60−100 % |
2× continuous green light | 30−60 % |
1× continuous green light | 5−30 % |
1× flashing green light | 0−5 % |
Battery model ProCORE18V...
LEDs | Capacity |
|---|---|
5× continuous green light | 80−100 % |
4× continuous green light | 60−80 % |
3× continuous green light | 40−60 % |
2× continuous green light | 20−40 % |
1× continuous green light | 5−20 % |
1× flashing green light | 0−5 % |
Changing the button cell (see figure A)
A warning will be displayed in the app before the button cell (12) is fully used up.
To open the battery compartment cover (11), turn it anticlockwise with a screwdriver and then lift off the battery compartment cover. Remove the empty button cell and insert a new button cell. Make sure that the battery holder is not damaged when removing the cell. Make sure that the positive pole of the button cell faces upwards.
Close the battery compartment cover back up.
