To unlock the holder sets (4), press the buttons (16) and open the levers (17) respectively.
Measure the distance x between the assembly holes on your power tool.
Position the holder sets (4) in the centre of the saw stand and at the appropriate distance x from each other.
Close each lever (17) again. This allows the holder sets to be firmly positioned on the saw stand.
Setting up the saw stand (see figure D)
Bring the power tool into the transport position. Information about the transport position can be found in the operating instructions for the corresponding power tool.
Position the movable nuts (18) in the holder sets so that they match the assembly holes on the power tool.
Screw using the supplied socket spanner (14) holder set and power tool with the hexagon screws and washers from the fastening set (19).
