Fitting the Auto-feed Attachment

Pull the standard depth stop off the drywall screwdriver if one is fitted.

Pull the bit holder off towards you if one is fitted. An auxiliary tool can be used to remove the bit or bit holder.

Insert a long screwdriver bit (1) into the tool holder (2) of the drywall screwdriver.

Slide the auto-feed attachment over the screwdriver bit (1) and onto the motor housing as far as it will go.

You can fit the auto-feed attachment offset in 45° increments. The auto-feed attachment cannot be rotated once it has been fitted on the drywall screwdriver.