Battery Charging

  • Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery of your power tool.

Note: The battery is supplied partially charged. To ensure full battery capacity, fully charge the battery in the charger before using your power tool for the first time.

The lithium-ion battery can be charged at any time without reducing its service life. Interrupting the charging process does not damage the battery.

The lithium-ion battery is protected against deep discharge by the "Electronic Cell Protection (ECP)". When the battery is discharged, the power tool is switched off by means of a protective circuit: The application tool no longer rotates.

Removing the Battery

The battery (18) is equipped with 2 locking levels to prevent the battery from falling out if the battery release button (17) is pressed unintentionally. The rechargeable battery is held in place by a spring when fitted in the power tool.

To remove the battery (18), press the release button (17) and pull the battery back and out of the power tool. Do not use force to do this.