Assembling the Mobile Base Unit

  • Carefully remove all parts included in the delivery from their packaging.
  • Remove all packing material.
  • For assembly, follow figures A−E2.

For figure B:

For easier orientation, the wheels are marked ("R" for right-hand wheel, "L" for left-hand wheel).

Note: Do not over-tighten the nuts. The screwed-together parts must be able to move freely.

For figure D:

Ensure that the support frame (18) is installed in the correct direction, as indicated by the "R" and "L" markings that match the wheels.

Note: Do not over-tighten the nuts. The screwed-together parts must be able to move freely.

For figure E1:

In this assembly step, the saw stand (2) is screwed to the support frame (18) and the support for the upper frame (13).

  • Turn both supports so that the holes in the sides of the supports point towards the handle.
  • While screwing the saw stand together, ensure that the support (8) is always in the holder on the lower frame (17).

Note: Only tighten the nuts slightly at first. Once all eight screws are positioned correctly, fully tighten all the nuts.

For figure E2:

Note: Do not over-tighten the nuts. The screwed-together parts must be able to move freely.