User interface (see figure B)

The user interface (9) is used to select the working mode and to indicate the status of the power tool.

Status indications

Power tool status indicator (25)

Colour

Meaning

Solution

Green

Power tool is switched on and ready to use.

−

Yellow

An event requires your attention: Critical temperature, battery almost empty or maintenance due.

  • Leave the power tool to cool down.
  • Replace or charge the battery.
  • Have maintenance carried out.

Red

The power tool is not ready for use.

Reason: The power tool has overheated, the battery is empty or there is a mechanical fault

  • Leave the power tool to cool down.
  • Replace or charge the battery.
  • Have maintenance carried out.

Flashing red

  • The trigger (6) was pressed too early.
  • The trigger (6) was not pressed within 5 s; the motor switches off automatically.
  • The controls were operated in the wrong order (e.g. the trigger was pressed before the power tool had switched to contact actuation mode).
  • Wait briefly until the status indicator lights up green.
  • The power tool is ready for use again.
  • Repeat the driving operation, observing the correct operating sequence.
  • Change the actuation mode via the User Interface.

Battery charge indicator (26)

Symbol

Paint

State of charge

–

–

20–100 %

Yellow

1–20 %

Red

0–1 %

Maintenance indicator

Symbol

Paint

Meaning

Solution

Yellow

"Low" level routine service is due.

Contact customer service.

Yellow

"High" level routine service is due.

Contact customer service.

Press the reset button (29) to reset the maintenance counter once the tool has been serviced.