Preselecting the Cutting Depth

The depth stop adjustment wheel (11) can be used to preset the required cutting depth.

Set the required cutting depth of the diamond cutting discs by turning the depth stop adjustment wheel (11) until the arrow mark (19) on the base plate (8) is pointing to the value of the required cutting depth (12). Ensure that the depth stop adjustment wheel (11) is engaged. Otherwise, the actual cutting depth may vary towards the larger or smaller value during operation. Due to wear on the diamond cutting discs, the actual cutting depth may be less than indicated by the preset cutting depth value (12). Check the actual penetration depth of the diamond cutting discs before use. The cutting depth can be set to 10 mm, 15 mm, 20 mm, 25 mm, 30 mm, 35 mm, 40 mm or MAX. The MAX setting ensures the maximum achievable cutting depth, however worn the diamond cutting discs may be.