Start-up

Before carrying out any work with the power tool, ensure that the chip container is closed and locked. Never operate the power tool without a protective guard/with a defective protective guard/lid on the chip container.

Make sure that you are able to press the On/Off switch without releasing the handle.

To start the power tool, first press the lock-off switch (6), then press and hold the on/off switch (7).

To switch off the power tool, release the on/off switch (7).

Note: For safety reasons, the on/off switch (7) cannot be locked; it must remain pressed during the entire operation.

An integrated run-out brake shortens the time the saw blade keeps running for after the power tool has been switched off.

The lithium-ion battery is protected against deep discharge by the Electronic Cell Protection (ECP). When the battery is discharged, the power tool is switched off by means of a protective circuit: The application tool no longer rotates.

The lamp (26) lights up when the on/off switch (7) is lightly or fully pressed, meaning that the work area is illuminated in poor lighting conditions.

Start-up

Switching on/off

Run-out brake

Protection Against Deep Discharging

Switching on the LED worklight