Dust/Chip Extraction
Do not perform work without taking dust-reducing measures. Using a suitable dust extraction attachment will reduce exposure to harmful dust. Provide good ventilation at the workplace. Always use suitable breathing protection. Use a dust extraction system that is suitable for the material wherever possible. The regulations on the materials being machined that apply in the country of use must be observed.
- Avoid dust accumulation at the workplace. Dust can easily ignite.
Requirements for the Dust Extractor | ||
|---|---|---|
Recommended hose nominal diameter | mm | 35 |
Required vacuum pressureA) | mbar | ≥ 230 |
Required flow rateA) | l/s | ≥ 36 |
Recommended filter efficiency | Dust class MB) | |
- A)
Power value at the power tool’s dust extractor connection
- B)
According to IEC/EN 60335-2-69
Refer to the dust extractor’s instructions. If there is reduced suction power, stop working and eliminate the cause.
Fitting the Chip Shield for Edge Routing/Dust Extraction Adapter (see figures M-N)
The chip shield for edge routing (30) and dust extraction adapter (32)/(33) can only be used in combination with the round base plate (7) and the optional square and D-shaped base plates (accessories).
The chip shield for edge routing (30) is particularly suitable for use in combination with the dust extraction adapter for edge routers (32). This ensures maximum dust extraction when routing edges.
Fit the chip shield for edge routing (30) with the supplied screw and click it audibly into the fixed routing base (2).
Connecting the Dust Extraction System
Put an extraction hose (dia. 35 mm) (accessory) on the installed dust extraction adapter. Connect the dust extraction hose to a dust extractor (accessory).
The dust extractor must be suitable for the material being worked.
When extracting dry dust or dust that is especially detrimental to health or carcinogenic, use a special dust extractor.