Preparations for Pressing and Pressing Process

Only insert the rechargeable battery into the power tool just before starting the pressing process. If, for example, you inadvertently press the on/off button (13) during the preparations for pressing, there is a risk of injury.

Never operate the power tool without inserting the press insert. Otherwise, the power tool may become damaged.

In order to prevent the power tool from overheating, do not use the power tool in continuous operation for more than 15 minutes. The power tool is not designed for continuous operation.

Preparations for Pressing:

Ensure that there is sufficient lighting at the place of use.
You can turn the press head (3) in order to align it suitably with the insertion position.
Open the press head (3) by pressing the unlocking lever (1). Position the press head at a right angle to the connector to be pressed. Ensure that there are no foreign objects between the press insert and the connector.
Close the press head (3) and ensure that you hear the unlocking lever (1) click into place.

Pressing Process:

Insert the rechargeable battery into the power tool.
To switch on and start the pressing process, press and hold the on/off button (13). The worklight (11) lights up.

Once the maximum pressing force has been reached, the piston rod (5) will move back with the press insert and the motor will switch off automatically. Release the on/off button (13). The worklight will go out automatically after approx. 10 s.

Manually Ending the Pressing Process:

To end the pressing process prematurely, release the on/off button (13) during the pressing process. The pressing process stops.
If the pressing process stops prematurely or the piston rod (5) does not move back automatically after the end of the pressing process, press the reset button (6). Hold the reset button down until the piston rod has moved back into the starting position.

Remove the battery from the power tool. Open the press head (3) by pressing the unlocking lever (1) and pull the power tool away from the connector.

If the status indicator (7) lights up green at the end of the pressing process, the maximum pressure has been reached. If the status indicator lights up red, check the pressing and, if necessary, repeat the processing process.