Inserting/Changing the Press Insert (see figures A−B)

Select the press insert set that matches the diameter and material of the connector.

You can find an overview of the Bosch press inserts according to the following standards at the end of these operating instructions:

DIN6 Series: DIN standard, Material: Aluminium
E6 Series: European standard (similar to DIN), Material: Copper
NF6 Series: French standard, Material: Copper
U6 Series: Italian standard, Material: Copper
SF6 Series: North European standard, Material: Copper

Further information about the recommended Bosch press inserts can also be found at www.bosch-pt.com or on a sticker in the power tool's XL-BOXX.

Ensure that the press inserts are clean and in perfect technical condition.

Press on the bottom end of the unlocking lever (1) on the press head in order to open the press head (3).

Push a press insert (2) into the side of both holders on the press head until you feel them click into place .

After inserting the press inserts, check whether they are both firmly locked in place. This will ensure that the press inserts do not inadvertently come loose during operation.

To remove a press insert (2), press the release button (4) at the front or rear of the press head (3) and push the press insert sideways out of the press head.