Product Features

The numbering of the product features refers to the diagram of the power tool on the graphics page.

(1)

Scale for spacing between saw blade and parallel guide

(2)

Angle guide

(3)

Protective cover

(4)

Riving knife

(5)

Parallel guide

(6)

Saw table expansion

(7)

Angle guide storage compartment

(8)

Mounting holes

(9)

Ring spanner (23 mm; 13 mm)

(10)

Hex key (5 mm)

(11)

Bracket for storing the protective cover

(12)

Push stick

(13)

Clamping handle for saw table expansion

(14)

Hand wheel

(15)

Crank for raising and lowering the saw blade

(16)

On/off switch

(17)

BatteryA)

(18)

Stop for 45° bevel angle

(19)

Scale for bevel angles

(20)

Locking lever for setting the bevel angle

(21)

Angle indicator (vertical)

(22)

Stop for 0° bevel angle

(23)

Saw table

(24)

Adjusting screw for adjusting the clamping force of the parallel guide

(25)

Table insert

(26)

Saw blade

(27)

Guide groove for parallel guide

(28)

Battery release buttonA)

(29)

Carrying handle

(30)

Guide groove for angle guide

(31)

Dust extraction adapter

(32)

V guide groove on the saw table for the parallel guide

(33)

Base grid

(34)

Locking screw for base grid

(35)

Clamping lever/clamp markings

(36)

Clamping lever for riving knife

(37)

Positioning pins for riving knife

(38)

Table insert locking screw

(39)

Clamping lever for protective cover

(40)

Guide pin for protective cover

(41)

Clamping handle for parallel guide

(42)

V guide for parallel guide

(43)

Additional parallel guide

(44)

"Additional parallel guide" fastening set

(45)

Guide rail for angle guide

(46)

Lower saw blade cover

(47)

Tab for lower saw blade cover

(48)

Gripping hole for lifting the table insert

(49)

Clamping nut

(50)

Spindle locking lever

(51)

Clamping flange

(52)

Mounting flange

(53)

Tool spindle

(54)

Locking knob for all mitre angles

(55)

Angle indicator on the angle guide

(56)

Scale display

(57)

Saw table spacing indicator

(58)

Cross-head screw for setting the 0° stop

(59)

Screw for bevel angle indicator

(60)

Cross-head screw for setting the 45° stop

(61)

Hex socket screws (5 mm) on the front for adjusting the parallelism of the saw blade

(62)

Hex socket screws (5 mm) on the rear for adjusting the parallelism of the saw blade

(63)

Screw for saw table spacing indicator

(64)

Hex socket screws (5 mm) for adjusting the parallelism of the parallel guide

(65)

Screw for parallel guide spacing indicator

(66)

Adjusting screws for table insert

(67)

Push stick storage compartment

(68)

Hex key storage compartment

(69)

Ring spanner storage compartment

A)

Accessories shown or described are not included with the product as standard. You can find the complete selection of accessories in our accessories range.