Start-up
- Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- To start the tool, press the on/off switch (31) and keep it pressed.
Note: For safety reasons, the on/off switch (31) cannot be locked; it must remain pressed during the entire operation.
Only by pressing the locking lever (13) can the tool arm be guided downwards.
- For sawing, you must therefore press the locking lever (13) in addition to pressing the On/Off switch (31).
The electronic starting current limitation feature restricts the power of the power tool when it is switched on and enables operation using a 16 A fuse.
Note: If the power tool runs at full speed immediately after being switched on, this means that the starting current limitation has failed. The power tool must be sent to the after-sales service without delay.